NonStop Operating System Event Management Programming Manual

Disk Process Event Messages (ZDSK)
HP NonStop Operating System Event Management Programming Manual—520372-020
11-27
Messages
Unconditional Tokens
Conditional Tokens
Cause. The disk has been changed or reset. This is a very common error when
performing path probing.
Effect. None.
Recovery. Informational message only; no corrective action is needed. If this error is
displayed only during a path probing and an input/output (I/O) operation is not
occurring, ignore it. Check for a valid additional sense code (ASC), which can indicate
that the drive has changed in its size.
-1006: ZDSK-EVT-SK-DATA-PRTCT
Indicates that a command that reads or writes the medium was tried on a block that is
protected.
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message.
Value is ZDSK-EVT-SK-UNIT-ATTN (-1005).
ZEMS-TKN-XLDEVNAME Subject token that specifies the logical device name
of the affected disk drive.
Token Description
ZEMS-TKN-LDEVNUMBER The logical device number of the affected disk drive.
ZDSK-TKN-LOGICAL-PATH-CMN Logical path command of the event.
ZEMS-TKN-SAC-NAME Nonshared token that is reserved for the vendor.
ZEMS-TKN-SCSI-TARGET-ID Nonshared token that is reserved for the vendor.
ZEMS-TKN-SCSI-LUN Nonshared token that is reserved for the vendor.
Subject: ZEMS-TKN-XLDEVNAME
Potentially critical event: No
Action event: No
Message sender: Disk process (ZDSK)
$ZLOG: Yes
$0: No
OSM/TSM collector: Yes
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZEMS-TKN-XLDEVNAME token-type ZSPI-TYP-STRING