NonStop Operating System Event Management Programming Manual

Disk Process Event Messages (ZDSK)
HP NonStop Operating System Event Management Programming Manual—520372-020
11-28
Messages
Unconditional Tokens
Conditional Tokens
Cause. Indicates that a command that reads or writes the medium was tried on a
block that is protected.
Effect. The read or write operation is not performed.
Recovery. None.
-1010: ZDSK-EVT-SK-ABORTED-CMND
A SCSI command has timed out and has been aborted. Possible causes are a SCSI
bus reset, a device reset, a controller error, or a ServerNet error.
Conditional Tokens
ZEMS-TKN-LDEVNUMBER token-type ZSPI-TYP-UINT
ZDSK-TKN-LOGICAL-PATH-CMN token-type ZSPI-TYP-UINT
ZEMS-TKN-SAC-NAME token-type ZSPI-TYP-INT4
ZEMS-TKN-SCSI-TARGET-ID token-type ZSPI-TYP-INT4
ZEMS-TKN-SCSI-LUN token-type ZSPI-TYP-INT4
Event-Message Text
SCSI SK - Data Protect
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message.
Value is ZDSK-EVT-SK-DATA-PRTCT (-1006).
ZEMS-TKN-XLDEVNAME Subject token that specifies the logical device name
of the affected disk drive.
Token Description
ZEMS-TKN-LDEVNUMBER The logical device number of the affected disk drive.
ZDSK-TKN-LOGICAL-PATH-CMN Logical path command of the event.
ZEMS-TKN-SAC-NAME Nonshared token that is reserved for the vendor.
ZEMS-TKN-SCSI-TARGET-ID Nonshared token that is reserved for the vendor.
ZEMS-TKN-SCSI-LUN Nonshared token that is reserved for the vendor.
Subject: ZEMS-TKN-XLDEVNAME
Potentially critical event: No
Action event: No
Message sender: Disk process (ZDSK)