NonStop Operating System Event Management Programming Manual

Disk Process Event Messages (ZDSK)
HP NonStop Operating System Event Management Programming Manual—520372-020
11-30
Messages
-1013: ZDSK-EVT-SK-MISCOMPARE
A source data mismatch has occurred during a write verify command. This can happen
because of bad controller hardware, SCSI command queuing, or an initial path switch
to the disk.
Unconditional Tokens
Conditional Tokens
Subject: ZEMS-TKN-XLDEVNAME
Potentially critical event: No
Action event: No
Message sender: Disk process (ZDSK)
$ZLOG: Yes
$0: No
OSM/TSM collector: Yes
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZEMS-TKN-XLDEVNAME token-type ZSPI-TYP-STRING
Conditional Tokens
ZEMS-TKN-LDEVNUMBER token-type ZSPI-TYP-UINT
ZDSK-TKN-LOGICAL-PATH-CMN token-type ZSPI-TYP-UINT
ZEMS-TKN-SAC-NAME token-type ZSPI-TYP-INT4
ZEMS-TKN-SCSI-TARGET-ID token-type ZSPI-TYP-INT4
ZEMS-TKN-SCSI-LUN token-type ZSPI-TYP-INT4
Event-Message Text
SCSI SK - Miscompare
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message.
Value is ZDSK-EVT-SK-MISCOMPARE (-1013).
ZEMS-TKN-XLDEVNAME Subject token that specifies the logical device name
of the affected disk drive.
Token Description
ZEMS-TKN-LDEVNUMBER The logical device number of the affected disk drive.
ZDSK-TKN-LOGICAL-PATH-CMN Logical path command of the event.
ZEMS-TKN-SAC-NAME Nonshared token that is reserved for the vendor.