NonStop Operating System Event Management Programming Manual

Disk Process Event Messages (ZDSK)
HP NonStop Operating System Event Management Programming Manual—520372-020
11-31
Messages
Cause. A source data mismatch has occurred during a write verify command. This can
happen because of a bad controller hardware, SCSI command queuing, or an initial
path switch to the disk.
Effect. If the controller is bad, the path to the disk might be brought down if an
alternative path is available.
Recovery. Informational message only; no corrective action is needed. If this event is
followed by a disk path down event, perform a recovery for the disk path down event.
Check the controller hardware.
-1014: ZDSK-EVT-RECOVERY-COMPLETION
Any request that has a problem that can be recovered by the I/O driver.
ZEMS-TKN-SCSI-TARGET-ID Nonshared token that is reserved for the vendor.
ZEMS-TKN-SCSI-LUN Nonshared token that is reserved for the vendor.
Subject: ZEMS-TKN-XLDEVNAME
Potentially critical event: No
Action event: No
Message sender: Disk process (ZDSK)
$ZLOG: Yes
$0: No
OSM/TSM collector: Yes
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZEMS-TKN-XLDEVNAME token-type ZSPI-TYP-STRING
ZDSK-TKN-RECOVERY-RESULT token-type ZSPI-TDT-ENUM
Conditional Tokens
ZEMS-TKN-LDEVNUMBER token-type ZSPI-TYP-UINT
ZDSK-TKN-LOGICAL-PATH-CMN token-type ZSPI-TYP-UINT
ZEMS-TKN-SAC-NAME token-type ZSPI-TYP-INT4
ZEMS-TKN-SCSI-TARGET-ID token-type ZSPI-TYP-INT4
ZEMS-TKN-SCSI-LUN token-type ZSPI-TYP-INT4
Event-Message Text
Recovery Completion
Token Description