NonStop Operating System Event Management Programming Manual

Disk Process Event Messages (ZDSK)
HP NonStop Operating System Event Management Programming Manual—520372-020
11-36
Messages
Unconditional Tokens
Conditional Tokens
Cause. A disk drive reported an internally or externally initiated path switch.
Effect. None.
Recovery. Informational message only; no corrective action is needed.
-1018: ZDSK-EVT-TIMEOUTS-EXCEEDED-CMN
The maximum number of interrupt timeouts for the I/O process (IOP) has been
exceeded.
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message.
Value is ZDSK-EVT-PATH-SWITCH-CMN (-1017).
ZEMS-TKN-XLDEVNAME Subject token that specifies the logical device name
of the affected disk drive.
ZDSK-TKN-CHANGE-INITIATOR-
CMN
Specifies the initiator of an action, whether it is an
internal (I/O) or external process (other process).
ZDSK-TKN-OLD-PATH-NAME The previous name of the path.
ZDSK-TKN-NEW-PATH-NAME The new name of the path.
Token Description
ZEMS-TKN-LDEVNUMBER The logical device number of the affected disk drive.
ZDSK-TKN-LOGICAL-PATH-CMN Logical path command of the event.
ZEMS-TKN-SAC-NAME Nonshared token that is reserved for the vendor.
ZEMS-TKN-SCSI-TARGET-ID Nonshared token that is reserved for the vendor.
ZEMS-TKN-SCSI-LUN Nonshared token that is reserved for the vendor.
Subject: ZEMS-TKN-XLDEVNAME
Potentially critical event: No
Action event: No
Message sender: Disk process (ZDSK)
$ZLOG: Yes
$0: No
OSM/TSM collector: Yes