NonStop Operating System Event Management Programming Manual

Disk Process Event Messages (ZDSK)
HP NonStop Operating System Event Management Programming Manual—520372-020
11-45
Messages
Unconditional Tokens
Conditional Tokens
Cause. An incomplete command was received by a disk drive.
Effect. The input/output (I/O) command fails.
Recovery. Reset the disk drive. If the error continues to occur, contact your service
provider and provide all relevant information as indicated under Recovery Action
Requiring Vendor Support on page 11-20.
-1029: ZDSK-EVT-DEV-BUSY
A command was not completed by the disk drive.
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message.
Value is ZDSK-EVT-DEV-CMD-INCOMP (-1028).
ZEMS-TKN-XLDEVNAME Subject token that specifies the logical device name
of the affected disk drive.
Token Description
ZEMS-TKN-LDEVNUMBER The logical device number of the affected disk drive.
ZDSK-TKN-LOGICAL-PATH-CMN Logical path command of the event.
ZEMS-TKN-SAC-NAME Nonshared token that is reserved for the vendor.
ZEMS-TKN-SCSI-TARGET-ID Nonshared token that is reserved for the vendor.
ZEMS-TKN-SCSI-LUN Nonshared token that is reserved for the vendor.
Subject: ZEMS-TKN-XLDEVNAME
Potentially critical event: No
Action event: No
Message sender: Disk process (ZDSK)
$ZLOG: Yes
$0: No
OSM/TSM collector: Yes
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZEMS-TKN-XLDEVNAME token-type ZSPI-TYP-STRING