NonStop Operating System Event Management Programming Manual

Disk Process Event Messages (ZDSK)
HP NonStop Operating System Event Management Programming Manual—520372-020
11-46
Messages
Unconditional Tokens
Conditional Tokens
Cause. A command was not completed by the disk drive.
Effect. The input/output (I/O) command fails.
Recovery. Reset the disk drive and reissue the command. If the error continues to
occur, contact your service provider and provide all relevant information as indicated
under Recovery Action Requiring Vendor Support
on page 11-20.
-1030: ZDSK-EVT-DEV-SCSI-STATUS
Unexpected SCSI status was received. When present, the event detail will help to
identify the specific problem.
Conditional Tokens
ZEMS-TKN-LDEVNUMBER token-type ZSPI-TYP-UINT
ZDSK-TKN-LOGICAL-PATH-CMN token-type ZSPI-TYP-UINT
ZEMS-TKN-SAC-NAME token-type ZSPI-TYP-INT4
ZEMS-TKN-SCSI-TARGET-ID token-type ZSPI-TYP-INT4
ZEMS-TKN-SCSI-LUN token-type ZSPI-TYP-INT4
Event-Message Text
Device Busy
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message.
Value is ZDSK-EVT-DEV-BUSY (-1029).
ZEMS-TKN-XLDEVNAME Subject token that specifies the logical device name
of the affected disk drive.
Token Description
ZEMS-TKN-LDEVNUMBER The logical device number of the affected disk drive.
ZDSK-TKN-LOGICAL-PATH-CMN Logical path command of the event.
ZEMS-TKN-SAC-NAME Nonshared token that is reserved for the vendor.
ZEMS-TKN-SCSI-TARGET-ID Nonshared token that is reserved for the vendor.
ZEMS-TKN-SCSI-LUN Nonshared token that is reserved for the vendor.
Subject: ZEMS-TKN-XLDEVNAME
Potentially critical event: No
Action event: No
Message sender: Disk process (ZDSK)