NonStop Operating System Event Management Programming Manual

Disk Process Event Messages (ZDSK)
HP NonStop Operating System Event Management Programming Manual—520372-020
11-49
Messages
Cause. A controller or a SCSI bus error occurred when a command was sent from the
controller to the disk drive.
Effect. The input/output (I/O) command fails.
Recovery. If the error continues to occur, contact your service provider and provide all
relevant information as indicated under Recovery Action Requiring Vendor Support on
page 11-20.
-1032: ZDSK-EVT-DEV-RESET
The disk drive was reset by a controller because a command from the controller to the
disk drive aborted.
ZEMS-TKN-SCSI-TARGET-ID Nonshared token that is reserved for the vendor.
ZEMS-TKN-SCSI-LUN Nonshared token that is reserved for the vendor.
Subject: ZEMS-TKN-XLDEVNAME
Potentially critical event: No
Action event: No
Message sender: Disk process (ZDSK)
$ZLOG: Yes
$0: No
OSM/TSM collector: Yes
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZEMS-TKN-XLDEVNAME token-type ZSPI-TYP-STRING
Conditional Tokens
ZEMS-TKN-LDEVNUMBER token-type ZSPI-TYP-UINT
ZDSK-TKN-LOGICAL-PATH-CMN token-type ZSPI-TYP-UINT
ZEMS-TKN-SAC-NAME token-type ZSPI-TYP-INT4
ZEMS-TKN-SCSI-TARGET-ID token-type ZSPI-TYP-INT4
ZEMS-TKN-SCSI-LUN token-type ZSPI-TYP-INT4
Event-Message Text
Device Reset
Token Description