NonStop Operating System Event Management Programming Manual

Disk Process Event Messages (ZDSK)
HP NonStop Operating System Event Management Programming Manual—520372-020
11-50
Messages
Unconditional Tokens
Conditional Tokens
Cause. The disk drive was reset by a controller because a command from the
controller to the disk drive aborted.
Effect. The input/output (I/O) command fails.
Recovery. The reset causes the command to be retried. If the error continues to
occur, contact your service provider and provide all relevant information as indicated
under Recovery Action Requiring Vendor Support on page 11-20.
-1034: ZDSK-EVT-SK-DEFERED-ERROR
Some error has already occurred and most likely this indicates that a write of the disk
drive's internal cache did not succeed.
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message.
Value is ZDSK-EVT-DEV-RESET (-1032).
ZEMS-TKN-XLDEVNAME Subject token that specifies the logical device name
of the affected disk drive.
Token Description
ZEMS-TKN-LDEVNUMBER The logical device number of the affected disk drive.
ZDSK-TKN-LOGICAL-PATH-CMN Logical path command of the event.
ZEMS-TKN-SAC-NAME Nonshared token that is reserved for the vendor.
ZEMS-TKN-SCSI-TARGET-ID Nonshared token that is reserved for the vendor.
ZEMS-TKN-SCSI-LUN Nonshared token that is reserved for the vendor.
Subject: ZEMS-TKN-XLDEVNAME
Potentially critical event: No
Action event: No
Message sender: Disk process (ZDSK)
$ZLOG: Yes
$0: Yes
OSM/TSM collector: Yes
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZEMS-TKN-XLDEVNAME token-type ZSPI-TYP-STRING