NonStop Operating System Event Management Programming Manual

Disk Process Event Messages (ZDSK)
HP NonStop Operating System Event Management Programming Manual—520372-020
11-63
Messages
Unconditional Tokens
Conditional Tokens
Cause. The disk process reporting the problem was unable to write audit to the audit
trail, or it detected a broken file during backout processing. Auditing on the affected
disk stops, but the disk remains in the up state.
Effect. The disk process reporting the problem no longer performs audited activity.
Nonaudited activity is not affected. Related messages might be displayed.
Recovery. Correct the audit-trail problem or correct the broken file. Then enable the
volume by using the TMFCOM ENABLE VOLUME command.
Event-Message Text
LDEV ldev
Volume {$vol} went down for TMF due to
{ error #dddddd on an audit write }
{ broken file detected during logical undo }
{ inability to post a control point TLE }
{ error #dddddd getting MAT info for a control point }
{ error #dddddd generating a control point }
{ error #dddddd writing the volume label }
{ error #dddddd on an audit write during a takeover }
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZDSK-
EVT-BADDOWN-TMF (5012).
ZEMS-TKN-LDEV Subject token that specifies the logical device
number of the affected disk drive.
ZDSK-TKN-BADDOWN-TMF-REASON Reason that the disk process for this volume can
no longer accept requests for audited files. Values
are listed under the description of token type
ZDSK-TKN-BADDOWN-TMF-REASON in Disk
Process (ZDSK-) Definitions on page 11-12.
Token Description
ZDSK-TKN-FILE-ERR File-system error number for the error that pertains to some
of the reasons indicated by the ZDSK-TKN-BADDOWN-
TMF-REASON.
ZDSK-TKN-VOL-NAME Name of the volume that will no longer accept requests
from audited files.