NonStop Operating System Event Management Programming Manual

Disk Process Event Messages (ZDSK)
HP NonStop Operating System Event Management Programming Manual—520372-020
11-64
Messages
5015: ZDSK-EVT-DRV-DOWN
The specified path has been placed in the down state (usually with the PUP DOWN
command for D-series NonStop operating system RVUs and with SCF STOP DISK
command for G-series and H-series NonStop operating system RVUs).
Unconditional Tokens
Cause. The specified path has been placed in the down state. The disk process
issues this message for each path as the path goes down. When the last path goes
down, the disk process displays this message without the channel specification on
D-series NonStop operating system RVUs and without path information on G-series
and H-series NonStop operating system RVUs.
Effect. The device goes down.
Recovery. Use the PUP UP command (D-series NonStop operating system RVUs) or
the SCF START DISK command (G-series and H-series NonStop operating system
RVUs) to bring up the device. If a PUP DOWN command (D-series) or a SCF STOP
DISK command (G-series and H-series) did not cause this message, see Recovery
Action Requiring Vendor Support on page 11-20.
Subject: ZEMS-TKN-LDEV
Potentially critical event: No
Action event: No
Message sender: Disk process (ZDSK)
TMDS collector: Yes
OSM/TSM collector: Yes
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZEMS-TKN-LDEV token-type ZSPI-TYP-UINT
Event-Message Text
D-series message text:
LDEV ldev [ CU %ccu ] DOWN
G-series and H-series message text:
LDEV ldev [ PATH: path DOWN ]
[PHYS ADDR: group, module, slot, target-id, lun, fabric,
sac-name ]
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZDSK-EVT-DRV-
DOWN (5015).
ZEMS-TKN-LDEV Subject token that specifies the logical device number of
the affected disk drive.