NonStop Operating System Event Management Programming Manual

Disk Process Event Messages (ZDSK)
HP NonStop Operating System Event Management Programming Manual—520372-020
11-65
Messages
5016: ZDSK-EVT-ERR-ELEM
An error occurred on a disk during a disk process elementary command.
Unconditional Tokens
Cause. The disk process issued an elementary command, and one of the following
errors occurred:

The drive is not ready.

The drive is not responding.

A drive-selection error occurred.
Subject: ZEMS-TKN-LDEV
Potentially critical event: Yes
Action event: No
Message sender: Disk process (ZDSK)
TMDS collector: Yes
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZEMS-TKN-LDEV token-type ZSPI-TYP-UINT
ZDSK-TKN-DRV-ERR token-type ZSPI-TYP-ENUM
ZDSK-TKN-LACCMD token-type ZSPI-TYP-ENUM
Event-Message Text
LDEV ldev CU %channel %unit %H DRIVE error LACCMD laccmd
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZDSK-EVT-ERR-
ELEM (5016).
ZEMS-TKN-LDEV Subject token that specifies the logical device number of
the affected disk drive.
ZDSK-TKN-DRV-ERR Drive error encountered (see Table 11-19
).
ZDSK-TKN-LACCMD Elementary controller command issued by the disk process.
Values are listed in Disk Process (ZDSK-) Definitions
on
page 11-12.
Table 11-19. ZDSK-TKN-DRV-ERR Values
Value Meaning
ZDSK-VAL-DRV-NOT-READY The drive is not ready.
ZDSK-VAL-DRV-NOT-RESPONDING The drive is not responding.
ZDSK-VAL-DRV-SELEC-ERR A drive-selection error occurred.