NonStop Operating System Event Management Programming Manual

Disk Process Event Messages (ZDSK)
HP NonStop Operating System Event Management Programming Manual—520372-020
11-69
Messages
Unconditional Tokens
Cause. The specified path has been placed in the up state by the PUP UP command
(D-series NonStop operating system RVUs) or by the System Control Facility (SCF)
command (G-series and H-series NonStop operating system RVUs). The disk process
issues this message for each path that comes up. When the first path comes up, the
disk process displays this message without the channel specification.
Effect. The path is up.
Recovery. This is an informational message only; no corrective action is needed.
5019: ZDSK-EVT-EXCEPT-ERR-ELEM
An exception error occurred on a disk during a disk process elementary command.
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZEMS-TKN-LDEV token-type ZSPI-TYP-UINT
Event-Message Text
LDEV ldev [ CU %ccu ] UP
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZDSK-EVT-DRV-
UP (5018).
ZEMS-TKN-LDEV Subject token that specifies the logical device number of
the affected disk drive.
Subject: ZEMS-TKN-LDEV
Potentially critical event: Yes
Action event: No
Message sender: Disk process (ZDSK)
TMDS collector: No
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZEMS-TKN-LDEV token-type ZSPI-TYP-UINT
ZDSK-TKN-EXCEPT-ERR token-type ZSPI-TYP-ENUM
ZDSK-TKN-LACCMD token-type ZSPI-TYP-ENUM
Event-Message Text
LDEV ldev CU %channel %unit %H error EXCEPTION LACCMD laccmd