NonStop Operating System Event Management Programming Manual

Disk Process Event Messages (ZDSK)
HP NonStop Operating System Event Management Programming Manual—520372-020
11-75
Messages
Recovery. Correct the error with the PUP LABEL command (D-series NonStop
operating system RVUs) or System Control Facility (SCF) command (G-series and
H-series NonStop operating system RVUs). See the Peripheral Utility Program (PUP)
Reference Manual for information about PUP commands and Subsystem Control
Facility (SCF) Reference Manual for SCF commands.
5022: ZDSK-EVT-INTERNAL-ERR
The disk process detected an internal error.
Unconditional Tokens
Cause. An internal error was detected in the disk process subsystem.
Effect. The disk process freezes the associated processor with a halt code of
%11500.
Recovery. Take a dump of the frozen processor, and see Recovery Action Requiring
Vendor Support on page 11-20.
Subject: ZEMS-TKN-LDEV
Potentially critical event: Yes
Action event: No
Message sender: Disk process (ZDSK)
TMDS collector: No
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZEMS-TKN-LDEV token-type ZSPI-TYP-UINT
ZDSK-TKN-INTERNAL-ERR token-type ZSPI-TYP-CHAR8
Event-Message Text
LDEV ldev
DP2 internal error detected at error label 'cccccccc'
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZDSK-EVT-
INTERNAL-ERR (5022).
ZEMS-TKN-LDEV Subject token that specifies the logical device number of
the affected disk drive.
ZDSK-TKN-INTERNAL-ERR ASCII error label that identifies the location where the
internal error occurred. This value is used by the vendor.