NonStop Operating System Event Management Programming Manual

Disk Process Event Messages (ZDSK)
HP NonStop Operating System Event Management Programming Manual—520372-020
11-78
Messages
5031: ZDSK-EVT-PENDING-STATUS
An attempt to issue a command was rejected with report-of-pending-status too many
times.
Unconditional Tokens
Cause. An attempt to issue a command was rejected with report-of-pending-status
more than an acceptable number of times.
Effect. Retries on this path have failed. Other paths are tried if they are available. The
drive goes down if no other paths are available.
Recovery. Check for a hardware problem in the disk, controller, or channel.
5032: ZDSK-EVT-REVIVE-ABORTED
A revive operation was aborted.
Subject: ZEMS-TKN-LDEV
Potentially critical event: Yes
Action event: No
Message sender: Disk process (ZDSK)
TMDS collector: No
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZEMS-TKN-LDEV token-type ZSPI-TYP-UINT
Event-Message Text
LDEV ldev CU %channel %unit %H EXCESSIVE PENDING STATUS RPTS
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZDSK-EVT-
PENDING-STATUS (5031).
ZEMS-TKN-LDEV Subject token that specifies the logical device number of
the affected disk drive.
Subject: ZEMS-TKN-LDEV
Potentially critical event: No
Action event: No
Message sender: Disk process (ZDSK)
TMDS collector: No