NonStop Operating System Event Management Programming Manual

Disk Process Event Messages (ZDSK)
HP NonStop Operating System Event Management Programming Manual—520372-020
11-79
Messages
Unconditional Tokens
Cause. An I/O error occurred during an attempt to revive the indicated disk, probably
because of a hardware error, and the revive operation was aborted.
Effect. The disk being revived goes down.
Recovery. For help with the hardware problem, see Recovery Action Requiring
Vendor Support on page 11-20. After the hardware problem is fixed, reissue the PUP
REVIVE command (D-series NonStop operating system RVUs). See the Peripheral
Utility Program (PUP) Reference Manual for information about PUP commands. On
G-series and H-series NonStop operating system RVUs, use the SCF START DISK
command. See the SCF Reference Manual for the Storage Subsystem for information
about SCF commands.
5033: ZDSK-EVT-SW-ERR
A checksum error occurred.
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZEMS-TKN-LDEV token-type ZSPI-TYP-UINT
Event-Message Text
REVIVE ABORTED
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZDSK-EVT-
REVIVE-ABORTED (5032).
ZEMS-TKN-LDEV Subject token that specifies the logical device number of
the affected disk drive.
Subject: ZEMS-TKN-LDEV
Potentially critical event: Yes
Action event: Yes
Message sender: Disk process (ZDSK)
TMDS collector: No
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT