NonStop Operating System Event Management Programming Manual

Disk Process Event Messages (ZDSK)
HP NonStop Operating System Event Management Programming Manual—520372-020
11-80
Messages
Unconditional Tokens
Conditional Tokens
Cause. This event was caused by a checksum error.
Effect. Data is corrupted.
Recovery. For D-series NonStop operating system RVUs, use the PUP SPARE
command. See the Peripheral Utility Program (PUP) Reference Manual for information
about this and other PUP commands.
For G-series and H-series NonStop operating system RVUs, use the CONTROL DISK
command. See the SCF Reference Manual for the Storage Subsystem for more
information about this and other SCF commands.
5034: ZDSK-EVT-REVIVE-SUSPENDED
An error occurred during a revive operation.
Conditional Tokens
ZEMS-TKN-LDEV token-type ZSPI-TYP-UINT
ZDSK-TKN-SW-ERR token-type ZSPI-TYP-UINT
ZDSK-TKN-SECTOR-ADDR token-type ZSPI-TYP-UINT
ZDSK-TKN-LOGICAL-PATH-CMN token-type ZSPI-TYP-UINT
Event-Message Text
PATH: SW DETECTED SECTOR XSUM ERROR
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZDSK-EVT-SW-
ERR (5033).
Token Description
ZEMS-TKN-LDEV Subject token that specifies the logical device number
of the affected disk drive.
ZDSK-TKN-LOGICAL-PATH-CMN Logical path command of the event.
ZDSK-TKN-SW-ERR Error number that occurred.
ZDSK-TKN-SECTOR-ADDR Sector number when a checksum error occurs.
Subject: ZEMS-TKN-LDEV
Potentially critical event: No
Action event: Yes
Message sender: DP2 Driver
TMDS collector: Yes
OSM/TSM collector: No