NonStop Operating System Event Management Programming Manual

Disk Process Event Messages (ZDSK)
HP NonStop Operating System Event Management Programming Manual—520372-020
11-81
Messages
Unconditional Tokens
Cause. Likely causes are sector checksum errors or uncorrectable ECC errors (on
reads issued to the source “UP” disk drive).
Effect. The revive will loop while waiting for the operator to resolve the problem.
Recovery. Determine what caused the revive error. Once the error is resolved, the
revive will resume.
5036: ZDSK-EVT-UNABLE-READ-DIR-LABEL
The disk process could not read the directory label.
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZEMS-TKN-LDEV token-type ZSPI-TYP-UINT
ZDSK-TKN-REVIVE-TIME-DELAY token-type ZSPI-TYP-INT2
ZDSK-TKN-REVIVE-CURR-SECT token-type ZSPI-TYP-LOGICAL-SECTOR
Event-Message Text
Revive-Suspended
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZDSK-EVT-
REVIVE-SUSPENDED (5034).
ZEMS-TKN-LDEV Subject token that specifies the logical device number
of the affected disk drive.
ZDSK-TKN-REVIVE-TIME-DELAY Current time between revive attempts.
ZDSK-TKN-REVIVE-CURR-SECT Sector number of the sector the revive operation is
attempting to revive. (This value might be slightly less
than the actual sector number in error.)
Subject: ZEMS-TKN-LDEV
Potentially critical event: Yes
Action event: No
Message sender: Disk process (ZDSK)
TMDS collector: No
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZEMS-TKN-LDEV token-type ZSPI-TYP-UINT
ZDSK-TKN-FILE-ERR token-type ZSPI-TYP-INT