NonStop Operating System Event Management Programming Manual

Disk Process Event Messages (ZDSK)
HP NonStop Operating System Event Management Programming Manual—520372-020
11-88
Messages
3 Report of pending status
4 Command exception
5 Channel-interface exception
6 Controller exception
7 Device-interface exception
8 Drive exception
9 ECC exception
A (not used)
B (not used)
C (not used)
D Drive not ready
E Drive-selection error
F Drive not responding
Table 11-25. ZEMS-TKN-PARM1 Values, Bits <8:15> (page 1 of 2)
Value
(Hexadecimal) Description
1 Bad boot ID
2 Bad command packet
3 Bad command response IOC residue
4 Bad controller parameter
5 Bad data IOC residue
6 Bad drive parameter
7 Bad ECC parameter
8 Bad extended parameter
9 Bad pending status
10 Bad response parameter length
11 Bad response packet length
12 ECC error with elementary command
13 Invalid encoded status
14 Invalid encoded status with extended command
15 Invalid IOC index
16 No response end ID parameter
17 Nonzero reserved fields
18 Response parameter not found
Table 11-24. ZEMS-TKN-PARM1 Values, Bits <4:7> (page 2 of 2)