NonStop Operating System Event Management Programming Manual

Disk Process Event Messages (ZDSK)
HP NonStop Operating System Event Management Programming Manual—520372-020
11-97
Messages
Unconditional Tokens
Conditional Tokens
Cause. The backup disk process detected a discontinuity in a checkpoint it received
from the primary disk process regarding a block in a particular file.
Effect. The file or table might contain stale or missing data.
Recovery. Inspect the file for data loss and inspect the Even Management Service
(EMS) event log for disk problems. See Recovery Action Requiring Vendor Support on
page 11-20.
5054: ZDSK-EVT-WRITE-FAILURE
The DP2 Driver encountered errors when attempting to write to a file.
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZDSK-EVT-DP2-
DATA-LOSS (5053).
ZEMS-TKN-LDEV Subject token that specifies the logical device number of
the affected disk drive.
ZDSK-TKN-FILE-NAME Internal representation of the name of the file whose
changes are being checkpointed.
ZDSK-TKN-FILE-RSN File-relative sector number of the block whose changes are
being checkpointed.
ZDSK-TKN-INTERNAL-ERR ASCII error label used by the vendor.
Token Description
ZDSK-TKN-LOGICAL-FILE-NAME SMF logical file name.
Subject: ZEMS-TKN-LDEV
Potentially critical event: Yes
Action event: No
Message sender: Disk process (ZDSK)
TMDS collector: No
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZEMS-TKN-LDEV token-type ZSPI-TYP-UINT
ZDSK-TKN-FILE-RSN token-type ZSPI-TYP-INT2
ZDSK-TKN-INTERNAL-ERR token-type ZSPI-TYP-CHAR8