NonStop Operating System Event Management Programming Manual

Disk Process Event Messages (ZDSK)
HP NonStop Operating System Event Management Programming Manual—520372-020
11-111
Messages
5068: ZDSK-EVT-CBPOOL-USAGE
This message provides information on the current use of DP2 control block pool space.
Unconditional Tokens
Cause. This is an informational message detected under one of the following
conditions:

DP2 was unable to obtain control block space. In this case, this message will be
preceded by event message ZDSK-EVT-NO-CBPOOL-SPACE (5067).

DP2 has successfully resized the control block segment. In this case, this message
is informational only.
Effect. If the message is detected because of a control block failure, then requests to
open or access files on the DP2 volume might incur allocation errors (33 or 35).
Recovery. If the message occurred because of control block failure, see 5067: ZDSK-
EVT-NO-CBPOOL-SPACE on page 11-110 for recovery actions.
Subject: ZEMS-TKN-LDEV
Potentially critical event: No
Action event: No
Message sender: Disk process (ZDSK)
TMDS collector: No
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZEMS-TKN-LDEV token-type ZSPI-TYP-UINT
ZDSK-TKN-POOL-SIZE token-type ZSPI-TYP-INT2
Event-Message Text
LDEV ldev
DP2 CBPool capacity is nKB, Maximum is nKB, Used is nKB.
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZDSK-EVT-
CBPOOL-USAGE (5068).
ZEMS-TKN-LDEV Subject token that specifies the logical device number of
the affected disk drive.
ZDSK-TKN-POOL-SIZE Occurs three times, specifying the control block capacity,
the maximum space, and the space used, all in kilobytes.