NonStop Operating System Event Management Programming Manual

Disk Process Event Messages (ZDSK)
HP NonStop Operating System Event Management Programming Manual—520372-020
11-126
Messages
Effect. While the primary processor continues to provide service, a failure by the
primary processor results in a down volume. This message is generated every five
minutes until the backup processor is reloaded and initializes successfully.
The DP2 volume will not be accessible if the primary processor fails.
Recovery. Reload the backup processor. If SCF support of DP2 is available, the
volume can be stopped and restarted.
If this message occurs after a system load or reload, see Recovery Action Requiring
Vendor Support on page 11-20.
5084: ZDSK-EVT-PROCESS-CREATE-TP
DP2 failed in an attempt to create a tailpin.
Unconditional Tokens
Cause. DP2 failed in an attempt to create a tailpin within the same processor.
Effect. The number of processes specified in the NUMDISCPROCESSES modifier in
the CONFTEXT configuration file will not be available for servicing requests.
Subject: ZEMS-TKN-LDEV
Potentially critical event: Yes
Action event: No
Message sender: Disk process (ZDSK)
TMDS collector: No
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZEMS-TKN-LDEV token-type ZSPI-TYP-UINT
ZDSK-TKN-ALL token-type ZSPI-TYP-INT
Event-Message Text
LDEV ldev ** ERROR **
DP2 process create of tailpin failed. Process_Create_
error is n, error detail is n
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZDSK-EVT-
PROCESS-CREATE-TP (5084).
ZEMS-TKN-LDEV Subject token that specifies the logical device number of
the affected disk drive.
ZDSK-TKN-ALL Occurs two times and specifies, in this order:
1. PROCESS_CREATE_ error number
2. PROCESS_CREATE_ error-detail number