NonStop Operating System Event Management Programming Manual

Disk Process Event Messages (ZDSK)
HP NonStop Operating System Event Management Programming Manual—520372-020
11-127
Messages
Recovery. If this event is reported during system load or reload, the primary and
backup processors of DP2 must be halted, dumped, and reloaded. If SCF support of
DP2 is available, the volume can be stopped and restarted.
If this message occurs after a system load or reload, see Recovery Action Requiring
Vendor Support on page 11-20.
5085: ZDSK-EVT-PROCESS-CREATE-BK
DP2 failed to create the brother processor headpin.
Unconditional Tokens
Cause. DP2 failed in an attempt to create the brother processor headpin.
Effect. The brother processor headpin might not start, and it will not be able to provide
service must the reporting processor fail.
Subject: ZEMS-TKN-LDEV
Potentially critical event: Yes
Action event: No
Message sender: Disk process (ZDSK)
TMDS collector: No
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZEMS-TKN-LDEV token-type ZSPI-TYP-UINT
ZDSK-TKN-ALL token-type ZSPI-TYP-INT
Event-Message Text
LDEV ldev ** ERROR **
DP2 process create of backup failed. Process_Create_ error
is n, error detail is n
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZDSK-EVT-
PROCESS-CREATE-BK (5085).
ZEMS-TKN-LDEV Subject token that specifies the logical device number of
the affected disk drive.
ZDSK-TKN-ALL Included two times and specifies, in the following order:
1. PROCESS_CREATE_ error number
2. PROCESS_CREATE_ error-detail number