NonStop Operating System Event Management Programming Manual

Disk Process Event Messages (ZDSK)
HP NonStop Operating System Event Management Programming Manual—520372-020
11-132
Messages
Unconditional Tokens
Cause. A softdown DP2 processor was reset by a PUP UP command (D-series
NonStop operating system RVUs) or an SCF START command (G-series and H-series
NonStop operating system RVUs).
Effect. The DP2 processor is fully restored to service.
Recovery. This is an informational message only; no corrective action is needed.
5090: ZDSK-EVT-OPER-ABORTED-DUMP
A DP2 TFDS data capture was aborted because of a PUP UP (D-series NonStop
operating system RVUs) or SCF START (G-series and H-series NonStop operating
system RVUs) request.
Event-Message Text
LDEV ldev
DP2 volume successfully recovered from internal software
error
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZDSK-EVT-
SOFTDOWN-RESET (5089).
ZEMS-TKN-LDEV Subject token that specifies the logical device number of
the affected disk drive.
Subject: ZEMS-TKN-LDEV
Potentially critical event: No
Action event: No
Message sender: Disk process (ZDSK)
TMDS collector: No
OSM/TSM collector: Yes (G-series and H-series)
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZEMS-TKN-LDEV token-type ZSPI-TYP-UINT
Event-Message Text (D-Series)
LDEV ldev
DP2 TFDS data capture aborted due to PUP UP request
Event-Message Text (G-Series and H-Series)
DP2 TFDS data capture aborted due to SCF START request