NonStop Operating System Event Management Programming Manual

Disk Process Event Messages (ZDSK)
HP NonStop Operating System Event Management Programming Manual—520372-020
11-133
Messages
Unconditional Tokens
Cause. A softdown DP2 processor was reset by a PUP UP command (D-series
NonStop operating system RVUs) or an SCF START command (G-series and H-series
NonStop operating system RVUs).
Effect. A Fault-tolerant protection is restored.
Recovery. This is an informational message only; no corrective action is needed.
5091: ZDSK-EVT-DP2-ABORTED-DUMP
The DP2-driver switched to the DP2 volume with a softdown processor request.
Unconditional Tokens
Cause. A softdown DP2 processor was reset because of a DP2-driver requested
processor switch.
Effect. A Fault-tolerant protection is restored.
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZDSK-EVT-
OPER-ABORTED-DUMP (5090).
ZEMS-TKN-LDEV Subject token that specifies the logical device number of
the affected disk drive.
Subject: ZEMS-TKN-LDEV
Potentially critical event: No
Action event: No
Message sender: Disk process (ZDSK)
TMDS collector: No
OSM/TSM collector: Yes
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZEMS-TKN-LDEV token-type ZSPI-TYP-UINT
Event-Message Text
LDEV ldev
DP2 TFDS data capture aborted due to takeover.
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZDSK-EVT-DP2-
ABORTED-DUMP (5091).
ZEMS-TKN-LDEV Subject token that specifies the logical device number of
the affected disk drive.