NonStop Operating System Event Management Programming Manual

Disk Process Event Messages (ZDSK)
HP NonStop Operating System Event Management Programming Manual—520372-020
11-134
Messages
Recovery. This is an informational message only; no corrective action is needed.
5093: ZDSK-EVT-SOFTDOWN-STATE
A DP2 processor has entered a softdown state.
Unconditional Tokens
Cause. A DP2 processor has entered a softdown state. This event is generated every
five minutes as a reminder to the operator to initiate a DP2 processor softdown
recovery.
Effect. The affected DP2 processor remains in a softdown state.
Subject: ZEMS-TKN-LDEV
Potentially critical event: Yes
Action event: Yes
Message sender: Disk process (ZDSK)
TMDS collector: No
OSM/TSM collector: No
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZEMS-TKN-LDEV token-type ZSPI-TYP-UINT
ZDSK-TKN-ALL token-type ZSPI-TYP-INT
Event-Message Text
LDEV ldev **WARNING**
DP2 CPU remains in an inconsistent state.
If possible, dump and reload the CPU.
A PUP UP (D-series) or SCF START (G-series and H-series) of
the volume will reset the backup to a consistent state, but
may prevent problem analysis.
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZDSK-EVT-
SOFTDOWN-STATE (5093).
ZEMS-TKN-LDEV Subject token that specifies the logical device number of
the affected disk drive.
ZDSK-TKN-ALL Occurs two times and specifies, in this order:
1. PROCESS_CREATE_ error number
2. PROCESS_CREATE_ error-detail number