NonStop Operating System Event Management Programming Manual

Disk Process Event Messages (ZDSK)
HP NonStop Operating System Event Management Programming Manual—520372-020
11-157
Messages
5116: ZDSK-EVT-BAD-HALT-ON-ERROR
A user has unsucessfully attempted to change whether an internally detected disk
process failure must force a halt (code %11500) in the primary processor, backup
processor, or both. This operation is performed with SCF by using the parameter
HaltOnError.
Unconditional Tokens
Cause. A user has attempted to change whether an internally detected disk process
failure must force a halt (code %11500) in the primary processor, backup processor, or
both, but has supplied an invalid value.
Effect.
The setting for internally detected disk process failure must force a halt (code
%11500) in the primary processor, backup processor, or both is not changed.
Recovery. Retry the operation. See the SCF Reference Manual for the Storage
Subsystem for information about changing this parameter.
Subject: ZEMS-TKN-LDEVNUMBER
Potentially critical event: No
Action event: No
Message sender: DP2 File Manager
TMDS collector: No
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZEMS-TKN-LDEVNUMBER token-type ZSPI-TYP-UINT
ZDSK-TKN-ALL(1)
ZDSK-TKN-ALL(2)
ZDSK-TKN-ALL(3)
Event-Message Text
Sysgen parameter Halt-On-Error value1 must be greater than or
equal to value2 and less than or equal to value3
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZDSK-EVT-ZDSK-
EVT-BAD-HALT-ON-ERROR (5116).
ZEMS-TKN-LDEVNUMBER Subject token that specifies the logical device number of
the affected disk drive.
ZDSK-TKN-ALL(1) Informational value.
ZDSK-TKN-ALL(2) Informational value.
ZDSK-TKN-ALL(3) Informational value.