NonStop Operating System Event Management Programming Manual

Low-Level I/O Event Messages (ZGIO)
HP NonStop Operating System Event Management Programming Manual—520372-020
3-19
Messages
1. No controller board plugged in
2. No power to controller
3. Incorrect SYSGEN
4. Controller port logic failure
Effect. None.
Recovery. See the Guardian Procedure Errors and Messages Manual for the
corrective action for the file-system error (given by ZGIO-TKN-FECODE). If the error
continues to occur, see Recovery Action Requiring Vendor Support on page 3-13.
105: ZGIO-EVT-CONTROLLERKILLED
The system issued an EIO kill command to disable the controller.
Unconditional Tokens
Cause. The sender processor detected a continually interrupting controller, so the
system issued an EIO kill command to disable the controller.
Subject: ZGIO-TKN-CHANNEL and ZGIO-TKN-CONTROLLER
Type of event: Channel-related
Potentially critical event: Yes
Action event: No
Message sender: Monitor process or I/O process
TMDS collector: Yes
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZEMS-MAP-EXIOADDR definition ZSPI-DDL-EXIOADDR
ZGIO-TKN-CHANNEL token-type ZSPI-TYP-UINT
ZGIO-TKN-CONTROLLER token-type ZSPI-TYP-BYTE
Event-Message Text
CONTROLLER %controller KILLED, CHANNEL %channel
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZGIO-EVT-
CONTROLLERKILLED (105).
ZEMS-MAP-EXIOADD External (physical) I/O address.
ZGIO-TKN-CHANNEL Subject token that specifies the channel affected by this
event.
ZGIO-TKN-CONTROLLER Subject token that specifies the controller number for the
event.