NonStop Operating System Event Management Programming Manual

Low-Level I/O Event Messages (ZGIO)
HP NonStop Operating System Event Management Programming Manual—520372-020
3-20
Messages
Effect. The sender processor cannot use this controller or any device attached to it
until the associated processor module is reloaded.
Recovery. Power off and then power on the offending controller. If the error continues
to occur, see Recovery Action Requiring Vendor Support on page 3-13.
106: ZGIO-EVT-CTLBUSY
The device controller rejected the EIO instruction because of an operation in progress.
Unconditional Tokens
Subject: ZGIO-TKN-CHANNEL, ZGIO-TKN-CONTROLLER, and
ZGIO-TKN-UNIT
Type of event: Device-related or controller-related
Potentially critical event: No
Action event: No
Message sender: I/O process
TMDS collector: Yes
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZEMS-MAP-EXIOADDR definition ZSPI-DDL-EXIOADDR
ZGIO-TKN-CHANNEL token-type ZSPI-TYP-UINT
ZGIO-TKN-CONTROLLER token-type ZSPI-TYP-BYTE
ZGIO-TKN-UNIT token-type ZSPI-TYP-BYTE
ZGIO-TKN-FECODE token-type ZSPI-TYP-BYTE
ZGIO-TKN-DEVSTAT token-type ZSPI-TYP-BYTE
ZGIO-TKN-CHANSTAT token-type ZSPI-TYP-BYTE
Event-Message Text
CONTROLLER %controller BUSY, CHANNEL %channel
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZGIO-EVT-
CTLBUSY (106).
ZEMS-MAP-EXIOADDR External (physical) I/O address.
ZGIO-TKN-CHANNEL Subject token that specifies the channel affected by this
event.
ZGIO-TKN-CONTROLLER Subject token that specifies the controller number for the
event.
ZGIO-TKN-UNIT Subject token that specifies the unit number for the event.
ZGIO-TKN-FECODE File-system error code returned when an invalid command
is sent to the device.