NonStop Operating System Event Management Programming Manual

NonStop Operating System Event Messages (ZNSK)
HP NonStop Operating System Event Management Programming Manual—520372-020
13-3
Topics:

Common Definitions on page 13-4

Description of ZNSK Event Messages on page 13-7
206: ZNSK-EVT-KMS-SWAP-MAXEXT-ALTER An NSKCOM ALTER command a
specified new value for MAXEXTENTS.
207: ZNSK-EVT-KMS-SWAP-THRES-ALTER
An NSKCOM ALTER command changed
the configured threshold for the swap file.
208: ZNSK-EVT-KMS-SWAP-STOP-PENDING
An NSKCOM STOP command has
stopped specified swap file.
209: ZNSK-EVT-KMS-SWAP-PURG-PENDING
An NSKCOM DELETE command
specified the indicated swap file.
210: ZNSK-EVT-KMS-CONFIG-NOTFOUND
A processor being disk booted or bus
booted did not find or could not open the
KMSF configuration file
$SYSTEM.SYSTEM.ZSYSCFG.
211: ZNSK-EVT-KMS-CONFIG-FILENAME
KMSF has found a configuration file.
212: ZNSK-EVT-KMS-CONFIG-ERROR
A syntax error was detected in the
ZSYSCFG configuration file during
startup.
213: ZNSK-EVT-KMS-SWAP-NOTFOUND
A swap file listed in the ZSYSCFG
configuration file was not found during
system startup.
214: ZNSK-EVT-KMS-SWAP-START-FAILED
A NSKCOM START command failed.
215: ZNSK-EVT-KMS-SWAP-DEFAULT
During system startup, either no swap files
were configured or the NonStop operating
system was unable to start the configured
swap files.
300: ZNSK-EVT-CORE-LIC-ENABLED
A Core license is enabled on the system.
301: ZNSK-EVT-CORE-LIC-FAILED
An online Core license Enablement failed.
302: ZNSK-EVT-CORE-LIC-DEF-ENABLED
The Core license Enablement failed at
coldload.
303: ZNSK-EVT-CORE-LIC-NOT-ENABLED
The Core license Enablement failed at
coldload, and no valid license file has
been installed and enabled since coldload
Table 13-1. NonStop Operating System Event Messages (page 3 of 3)
Event Number and Symbolic Name Description