NonStop Operating System Event Management Programming Manual

NonStop Operating System Event Messages (ZNSK)
HP NonStop Operating System Event Management Programming Manual—520372-020
13-34
Messages
Recovery. This is an informational message only; no corrective action is needed.
203: ZNSK-EVT-KMS-SWAP-START
The specified KMSF swap file was started.
Unconditional Tokens
Cause. The indicated swap file was enabled for use either by KMSF after the disk
containing the swap file came up or by the NSKCOM START command.
Effect. The swap file is available for use by the indicated processor.
Recovery. This is an informational message only; no corrective action is needed.
204: ZNSK-EVT-KMS-SWAP-STOPPED
Use of the indicated KMSF swap file was stopped.
Subject: ZNSK-TKN-FILE
Potentially critical event: No
Action event: No
Message sender: NSKCOM process
TMDS collector: No
OSM/TSM collector: No
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZNSK-TKN-FILE token-type ZSPI-TYP-STRING
ZNSK-TKN-CPU token-type ZSPI-TYP-INT
Event-Message Text
KMSF SWAPFILE STARTED: swapfile CPU cpu
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZNSK-EVT-KMS-
SWAP-START (203).
ZNSK-TKN-FILE Subject token that specifies the name of the swap file that
was started.
ZNSK-TKN-CPU Processor number of the processor associated with the
swap file.
Subject: ZNSK-TKN-FILE
Potentially critical event: Yes
Action event: No