NonStop Operating System Event Management Programming Manual

NonStop Operating System Event Messages (ZNSK)
HP NonStop Operating System Event Management Programming Manual—520372-020
13-42
Messages
Unconditional Tokens
Cause. During startup, a syntax error was detected in the ZSYSCFG configuration file.
Normally, this message is not issued if NSKCOM is used to configure swap files and to
view and alter the configuration file. The ZSYSCFG file is intended to be altered only
by the NSKCOM program. If this message is issued, someone has probably attempted
to edit the file.
If there are multiple lines with errors in the ZSYSCFG file, this message is generated
for each line.
Effect. The specified line of the configuration file is ignored. Any swap file specified on
that line is not added or enabled for use. If there is no swap file configured for a
processor, KMSF attempts to create a default swap file for the processor. If KMSF
cannot create a default swap file, the processor does not come up. The next time a
super-group user (255, n) runs NSKCOM, the KMSF deletes that line from the
configuration file.
Recovery. Print the ZSYSCFG configuration file and note the contents of the line that
is in error. Run NSKCOM as a super-group user (255, n) to correct the KMSF
configuration. If a swap file was specified on the erroneous line, use NSKCOM to add
and enable use of the swap file.
If the error recurs or is not resolved through NSKCOM, see Recovery Action Requiring
Vendor Support on page 13-8.
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZNSK-TKN-LINE-NUM token-type ZSPI-TYP-STRING
Event-Message Text
KMSF CONFIGURATION FILE SYNTAX ERROR ON LINE NUMBER:line-num
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZNSK-EVT-KMS-
CONFIG-ERROR (212).
ZNSK-TKN-LINE-NUM EDIT line number where the syntax error was detected in
the ZSYSCFG file.