NonStop Operating System Event Management Programming Manual

NonStop Operating System Event Messages (ZNSK)
HP NonStop Operating System Event Management Programming Manual—520372-020
13-44
Messages
214: ZNSK-EVT-KMS-SWAP-START-FAILED
An attempt to start a KMSF swap file failed.
Unconditional Tokens
Cause. An attempt to enable use of a KSMF swap file with an NSKCOM START
command failed. This error can occur during startup or after a START command is
entered. Possible reasons for failure include:

The disk containing the swap file is down.

The swap file’s code is incorrect. This must occur only if the swap file was created
using a program other than NSKCOM or if the file code was altered.

The swap file is incorrectly specified for multiple processors and is already in use
by another processor.

Not enough additional physical memory is available on the system.
Effect. The swap file is not used. If there is a heavy demand for swap space, this
might slow system performance.
Subject: ZNSK-TKN-FILE
Potentially critical event: Yes
Action event: No
Message sender: Monitor process
TMDS collector: No
OSM/TSM collector: No
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZNSK-TKN-FILE token-type ZSPI-TYP-STRING
ZNSK-TKN-CPU token-type ZSPI-TYP-INT
Event-Message Text
KMSF SWAPFILE START FAILED: swapfile CPU cpu
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZNSK-EVT-KMS-
SWAP-START-FAILED (214).
ZNSK-TKN-FILE Subject token that specifies the name of the KMSF swap
file that could not be started.
ZNSK-TKN-CPU Processor number of the processor associated with the
swap file.