NonStop Operating System Event Management Programming Manual

Nonstop Operating System Message System Event
Messages (ZIPC)
HP NonStop Operating System Event Management Programming Manual—520372-020
16-11
Description of ZIPC Event Messages
Description of ZIPC Event Messages
The ZIPC event messages are described in detail on the following pages. The
descriptions are in ascending order by event number. The symbolic name for the event
number is ZIPC-EVT-name, where name describes the event that generated the
message.
Topics:

Information in Event Description Messages on page 16-11

Recovery Action Requiring Vendor Support on page 16-12

Descriptions of individual event messages (for a linked list, see Table 16-1 on
page 16-1)
Information in Event Description Messages
Each description contains the following information:

A header showing the numeric value and symbolic name for the event number.

A paragraph describing the event message.

A list:

Identifying the subject of the event message.

Indicating whether the event is channel-related, device-related, or controller-
related.

Indicating whether the message identifies a potentially critical event (whether
ZEMS-TKN-EMPHASIS has the value ZSPI-VAL-TRUE).

Indicating whether the message identifies an action-attention event (whether
ZEMS-TKN-ACTION-NEEDED has the value ZSPI-VAL-TRUE).

Identifying the sender of the event message to the EMS collector ($0 process).

Indicating whether the event message is sent to the TMDS collector (D-series
NonStop operating system RVUs) or OSM/TSM collector (G-series and H-
series NonStop operating system RVUs).
Note. Each event message also contains the header tokens listed in Section 2, Header and
Common Tokens, and the tokens listed in the Common Definitions on page 3-5.