NonStop Operating System Event Management Programming Manual

Nonstop Operating System Message System Event
Messages (ZIPC)
HP NonStop Operating System Event Management Programming Manual—520372-020
16-16
Messages
Unconditional Tokens
Conditional Token
Cause. The problem processor might be down or recovering from a power failure.
Also, this event might be caused by a protocol error on the part of the
message-system.
Conditional Token
ZIPC-TKN-PROBLEM-NODE token-type ZSPI-TYP-UINT
Event-Message Text
ServerNet nack received on the path path by processor
reporting-cpu from processor problem-cpu {in ServerNet node
node-number}.
Details of the nack are:
Nack status code: nack-code
Sib used for transfer: sib-type
ServerNet address used for transfer: snet-addr
Bytecount for transfer: byte-count
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZIPC-EVT-DET-
NACK-RCVD (102).
ZIPC-TKN-REPORTING-CPU Processor number of the processor on which the error
was detected.
ZIPC-TKN-PROBLEM-CPU Subject token that specifies the processor in which the
message originated.
ZIPC-TKN-PATH Fabric over which the message was transmitted.
ZIPC-TKN-NACK-CODE ServerNet NACK code contained in the packet.
ZIPC-TKN-SIB-TYPE Presents the type of Send Info Block (SIB, a message
system data structure) that was used by the sending
logic to send the packet that was rejected in this event.
ZIPC-TKN-SNET-ADDR-USED Target ServerNet address in the packet.
ZIPC-TKN-BYTE-COUNT-USED Length of the packet received, in bytes.
Token Description
ZIPC-TKN-PROBLEM-NODE Node number of the node containing the problem
processor. This is an optional token and is not passed on if
the reporting and problem processors are in the same
(local) node.