NonStop Operating System Event Management Programming Manual

Nonstop Operating System Message System Event
Messages (ZIPC)
HP NonStop Operating System Event Management Programming Manual—520372-020
16-17
Messages
Effect. If the error is because of a power fail recovery or the nack status code
indicates an interrupt to a full queue, the packet will eventually be resent. Otherwise,,
both plans will be downed and communication to the problem processor will be
severed. If the problem and reporting processors are in the same system, regroup will
be invoked, which will halt one of the processors.
Recovery. This is an informational message only; no corrective action is needed
unless a processor halts. If a processor does halt, see Recovery Action Requiring
Vendor Support on page 16-12.
103: ZIPC-EVT-DET-BAD-DID-PKT-RCVD
The reporting processor has received a message with a bad destination address.
Subject: ZIPC-TKN-PROBLEM-CPU
Potentially critical event: No
Action event: No
Message sender: Monitor process
TMDS collector: No
OSM/TSM collector: Yes
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-ENUM
ZIPC-TKN-REPORTING-CPU token-type ZSPI-TYP-UINT
ZIPC-TKN-PROBLEM-CPU token-type ZSPI-TYP-UINT
ZIPC-TKN-PATH token-type ZSPI-TYP-ENUM
ZIPC-TKN-TR-TYPE token-type ZSPI-TYP-ENUM
ZIPC-TKN-SNET-ADDR-USED token-type ZSPI-TYP-INT2
ZIPC-TKN-BYTE-COUNT-USED token-type ZSPI-TYP-INT2
ZIPC-TKN-DEST-FIELD-ADDR token-type ZSPI-TYP-INT2
Conditional Token
ZIPC-TKN-PROBLEM-NODE token-type ZSPI-TYP-UINT
Event-Message Text
Bad destination ServerNet packet received on the path path by
processor reporting-cpu from processor problem-cpu {in
ServerNet node node-number}.
Details of the bad packets are:
ServerNet transaction type: tr-type
ServerNet address used: snet-addr
Packet byte count in packet: byte-count
Intended destination node: dest-node