NonStop Operating System Event Management Programming Manual

Nonstop Operating System Message System Event
Messages (ZIPC)
HP NonStop Operating System Event Management Programming Manual—520372-020
16-21
Messages
Unconditional Tokens
Conditional Token
Cause. The message system has brought down the path used by the reporting
processor in order to communicate with the problem processor.
Effect. The downed path will no longer be used for communication between the
indicated processors.
Recovery. The operator can try to bring the path back up using the SCF START
SERVERNET command. Alternatively, unless the path was downed by the operator
(SCF command) or because of fabric failure, automatic path recovery will attempt to
recover the path.
111: ZIPC-EVT-PATH-UP
The communication path between the reporting and problem processors, via the
indicated fabric, has been re-established.
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZIPC-EVT-PATH-
DOWN (110).
ZIPC-TKN-REPORTING-CPU Processor number of the processor on which the error was
detected.
ZIPC-TKN-PROBLEM-CPU Subject token that specifies the processor in which the
message originated.
ZIPC-TKN-PATH Fabric over which the message was transmitted.
ZIPC-TKN-PATH-REASON Reason the path was taken down. If the reason is ZIPC-
VAL-MAX-RETRIES, the optional “OPERATOR
ATTENTION NEEDED” message is displayed.
Token Description
ZIPC-TKN-PROBLEM-NODE Node number of the node containing the problem
processor. This is an optional token and is not passed if the
reporting and problem processors are in the same (local)
node.
Subject: ZIPC-TKN-PROBLEM-CPU
Potentially critical event: No
Action event: No
Message sender: Monitor process
TMDS collector: No
OSM/TSM collector: Yes