NonStop Operating System Event Management Programming Manual

NonStop Subsystem Manager Event Messages
(ZKRN)
HP NonStop Operating System Event Management Programming Manual—520372-020
17-5
Description of ZKRN Event Messages
Description of ZKRN Event Messages
The NonStop subsystem manager event messages are described in detail on the
following pages. The descriptions are in ascending order by event number. The
symbolic name for the event number is ZKRN-EVT-name, where name describes the
event that generated the message.
Topics:

Information in Event Description Messages on page 17-5

Recovery Action Requiring Vendor Support on page 17-6

Descriptions of individual event messages (for a linked list, see Table 17-1 on
page 17-1)
Information in Event Description Messages
Each description contains the following information:

A header showing the numeric value and symbolic name for the event number.

A paragraph describing the event message.

A list:

Identifying the subject of the event message.

Indicating whether the event is channel-related, device-related, or controller-
related.

Indicating whether the message identifies a potentially critical event (whether
ZEMS-TKN-EMPHASIS has the value ZSPI-VAL-TRUE).

Indicating whether the message identifies an action-attention event (whether
ZEMS-TKN-ACTION-NEEDED has the value ZSPI-VAL-TRUE).

Identifying the sender of the event message to the EMS collector ($0 process).

Indicating whether the event message is sent to the TMDS collector (D-series
NonStop operating system RVUs) or OSM/TSM collector (G-series and H-
series NonStop operating system RVUs).
Note. Each event message also contains the header tokens listed in Section 2, Header and
Common Tokens, and the tokens listed in the Common Definitions on page 3-5.