NonStop Operating System Event Management Programming Manual

NonStop Subsystem Manager Event Messages
(ZKRN)
HP NonStop Operating System Event Management Programming Manual—520372-020
17-11
Messages
Cause. A default KRN_SUBSYS record was added to the system configuration
database because no KRN_SUBSYS record was found in the system configuration
database. This message occurs when the system is loaded from CONFBASE.
Effect. None.
Recovery. This is an informational message only; no corrective action is needed. If
you want to change the default values, use the SCF ALTER SUBSYS command (for
more information about this command, see the SCF Reference Manual for the Kernel
Subsystem).
8: ZKRN-EVT-DCT-ALTERED-SMALL
The size of the DCT was changed to SMALL (32,766 entries) in the system
configuration.
Unconditional Token
Cause. You used the SCF ALTER SUBSYS command to change the size of the DCT
to SMALL (32,766 entries).
Effect. None.
Recovery. This is an informational message only; no corrective action is needed.
Subject: ZKRN-EVT-DCT-ALTERED-SMALL
Potentially critical event: No
Action event: No
Message sender: NonStop Subsytem Manager
TMDS collector: No
OSM/TSM collector: Yes
Unconditional Token
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
Event-Message Text
Size of DCT altered to SMALL (32766) in system configuration.
The new DCT Size takes effect immediately.
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZKRN-EVT-DCT-
ALTERED-SMALL (8).