NonStop Operating System Event Management Programming Manual

NonStop C-Base Multitasking Engine (NSC) Event
Messages (ZNSC)
HP NonStop Operating System Event Management Programming Manual—520372-020
18-15
Messages
Cause. An error occurred during a checkpointing of the global data, causing NSC to
fail to complete the initial checkpoint to a backup process.
Effect. NSC stops the backup process, then restarts it 10 seconds later.
Recovery. If the problem persists, see Recovery Action Requiring Vendor Support on
page 18-7.
9: ZNSC-EVT-BKP-LOST
A backup process was terminated.
Unconditional Tokens
Cause. Either the processor where the backup process was executing failed, an
operator stopped the backup process, or the backup process ended abnormally.
Effect. The process using NSC is no longer running as a process pair. NSC
automatically recreates the backup process when it is possible to do so (that is, when
the processor in which the backup process must run is available).
Recovery. If the problem persists, see Recovery Action Requiring Vendor Support on
page 18-7.
Subject: ZNSC-TKN-PROC-NAME
Potentially critical event: No
Action event: No
Message sender: Processes using NSC
TMDS collector: No
OSM/TSM collector: Yes
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZNSC-TKN-PROC-NAME token-type ZSPI-TYP-STRING
ZNSC-TKN-RESULT token-type ZSPI-TYP-UINT
Event-Message Text
Backup process lost, completion code code
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZNSC-EVT-BKP-
LOST (9).
ZNSC-TKN-PROC-NAME Subject token that specifies the process name of the
process using NSC.
ZNSC-TKN-RESULT Process completion code returned.