NonStop Operating System Event Management Programming Manual

ServerNet Error Handler Event Messages (ZSNT)
HP NonStop Operating System Event Management Programming Manual—520372-020
19-49
Messages
Unconditional Tokens
Cause. When a software subsystem that interacts over a ServerNet link is deinstalled,
an interrupt packet can be posted to the subsystem. Such interrupts cause the
“interrupt with no device” error to occur.
Effect. These interrupts are counted and if too many such interrupts occur, that
ServerNet link is no longer used. The error causing the interrupt packet is dropped.
Recovery. This is an informational message only; no corrective action is needed.
1030: ZSNT-EVT-EXC-QUEUE-ERRORS
An exception address validation and translation (AVT) entry was incorrectly
programmed or the exception interrupt queue was full.
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZSNT-TKN-CPU-NUMBER token-type ZSPI-TYP-INT
ZSNT-TKN-NO-DEVICE-INT-ERRORS token-type ZSPI-TYP-INT2
ZSNT-TKN-FABRIC-NUMBER token-type ZSNT-TYP-FABRIC
Event-Message Text
CPU cpu: Interrupt With No Device Errors errors
Occurred on Fabric fabric-number
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZSNT-
EVT-NO-DEVICE-INT-ERRORS (1029).
ZSNT-TKN-CPU-NUMBER Subject token that specifies the processor that
encountered the error.
ZSNT-TKN-NO-DEVICE-INT-ERRORS Number of times the interrupt with no device error
occurred.
ZSNT-TKN-FABRIC-NUMBER Fabric where the error occurred (0 for X, 1 for Y).
Subject: ZSNT-TKN-CPU-NUMBER
Potentially critical event: No
Action event: No
Message sender: GenErr
$ZLOG: Yes
$0: No