NonStop Operating System Event Management Programming Manual

ServerNet Error Handler Event Messages (ZSNT)
HP NonStop Operating System Event Management Programming Manual—520372-020
19-53
Messages
Conditional Tokens (G-Series Only)
Cause. The receiver read request buffer received more than the maximum allowed
number of read request packets.
Effect. These interrupts are counted, and if too many such interrupts occur, the
processor halts.
Recovery. This is an informational message only; no corrective action is needed.
1033: ZSNT-EVT-QUEUE-FULL-ERRORS
The interrupt queue logic detected a queue-full condition after posting an interrupt.
Token Description
ZSNT-TKN-CAUSE-REG Interrupt Cause Register at the time of the exception.
ZSNT-TKN-LINK-XCEPT-X Port X Link Exception Register.
ZSNT-TKN-LINK-XCEPT-Y Port Y Link Exception Register.
Subject: ZSNT-TKN-CPU-NUMBER
Potentially critical event: No
Action event: No
Message sender: GenErr
$ZLOG: Yes
$0: No
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZSNT-TKN-CPU-NUMBER token-type ZSPI-TYP-INT
ZSNT-TKN-QUEUE-FULL-ERRORS token-type ZSPI-TYP-INT2
Conditional Tokens (G-Series Only)
ZSNT-TKN-CAUSE-REG token-type ZSPI-TYP-INT2
ZSNT-TKN-LINK-XCEPT-X token-type ZSPI-TYP-INT2
ZSNT-TKN-LINK-XCEPT-Y token-type ZSPI-TYP-INT2
Event-Message Text
CPU cpu: Interrupt Queue Full Errors errors Occurred
[ Cause Reg: 0xcause-reg, Link Exception X: 0xlink-xcept-x,
Link Exception Y: 0xlink-xcept-y ]