NonStop Operating System Event Management Programming Manual

ServerNet Error Handler Event Messages (ZSNT)
HP NonStop Operating System Event Management Programming Manual—520372-020
19-72
Messages
Unconditional Tokens
Conditional Token
Cause. A packet transmission did not complete, and normal software and hardware
timer functions did not detect the error.
Effect. The data was not completely transmitted. Data transmissions to multiple
destinations on the same fabric will time out. A higher-level software transmission
protocol might detect that the data did not arrive and attempt recovery.
Recovery. This is an informational message only; no corrective action is needed.
Event-Message Text
Processor cpunum: count BTE Timer expiration event(s) have
occurred.
[ Additional info at the time of the first expiration:
Device: devicenum
BTE: btenum
BTE Hdr1: hdr1val
BTE Hdr2: hdr2val
BuffAddr: bufferaddress
Status: transmitstatus ]
[ Additional info at the time of the last expiration:
Device: devicenum
BTE: btenum
BTE Hdr1: hdr1val
BTE Hdr2: hdr2val
BuffAddr: bufferaddress
Status: transmitstatus ]
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZSNT-EVT-
BTE-TIMER-POP (1049).
ZEMS-TKN-EMPHASIS Value is ZSPI-VAL-FALSE.
ZSNT-TKN-CPU-NUMBER Subject token that specifies the processor on which the
event occurred.
ZSNT-TKN-BTE-TIMER-POP Number of errors of this type detected by ServerNet
since the last event was generated.
Token Description
ZSNT-TKN-BTE-TIMER-POP-S Uses the ZSNT-DDL-BTE-TIMER-POP-S structure
definition, which holds information about the BTE
command that was executing. There can be up to two of
these structures associated with the event.