NonStop Operating System Event Management Programming Manual

ServerNet Error Handler Event Messages (ZSNT)
HP NonStop Operating System Event Management Programming Manual—520372-020
19-86
Messages
Cause. ServerNet error-logging software detected either an interface error or an
internal error.
Effect. An expected event might not generate properly.
Recovery. This is an informational message only; no corrective action is needed.
1059: ZSNT-EVT-SINGLE-SYMBOL
ServerNet Hardware detected the transmission of a Single Symbol.
Unconditional Tokens
Cause. The ServerNet hardware detected the transmission of a Single Symbol, which
is an abnormal condition except during low-level hardware tests.
Subject: ZSNT-TKN-CPU-NUMBER
Potentially critical event: No
Action event: No
Message sender: GenErr
$ZLOG: Yes
$0: No
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-ENUM
ZEMS-TKN-EMPHASIS token-type ZSPI-TYP-BOOLEAN
ZSNT-TKN-CPU-NUMBER token-type ZSPI-TYP-INT
ZSNT-TKN-FABRIC-NUMBER token-type ZSNT-TYP-FABRIC
ZSNT-TKN-SYMBOL-CTL-REG token-type ZSPI-TYP-INT2
ZSNT-TKN-SSYMBOL-DATA token-type ZSPI-TYP-INT2
Event-Message Text
Processor cpunum: A single ServerNet symbol was sent on port
fabric. The Control Register is ctlreg, the data sent was
symboldata.
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZSNT-EVT-
SINGLE-SYMBOL (1059).
ZEMS-TKN-EMPHASIS Value is ZSPI-VAL-FALSE.
ZSNT-TKN-CPU-NUMBER Subject token that specifies the processor on which the
event occurred.
ZSNT-TKN-SYMBOL-CTL-REG Contents of the Single Symbol Transmit Control register
when the symbol was transmitted.
ZSNT-TKN-SSYMBOL-DATA Data in the symbol that was transmitted.