NonStop Operating System Event Management Programming Manual

Low-Level I/O Event Messages (ZGIO)
HP NonStop Operating System Event Management Programming Manual—520372-020
3-53
Messages
140: ZGIO-EVT-SCHANLRCIERROR
A reconnect request (RCI) was sent but no device controller responded to the
reconnect poll.
Unconditional Tokens
Cause. The controller requesting initial data transfer failed to respond to the initial data
transfer protocol.
Effect. The channel is unable to identify the failing component in this situation. If this
condition persists, the operating system brings down the channel.
Recovery. If the error continues to occur, see Recovery Action Requiring Vendor
Support on page 3-13.
Subject: ZGIO-TKN-CHANNEL
Type of event: Channel-related
Potentially critical event: No
Action event: No
Message sender: Monitor process
TMDS collector: Yes
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZEMS-MAP-EXIOADDR definition ZSPI-DDL-EXIOADDR
ZGIO-TKN-CHANNEL token-type ZSPI-TYP-UINT
ZGIO-TKN-CHANNELTAG token-type ZSPI-TYP-UINT
Event-Message Text
RCI ASSERTED WITH NO RANK0/RANK1 DEVICE RESPONSE
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZGIO-EVT-
SCHANLRCIERROR (140).
ZEMS-MAP-EXIOADDR External (physical) I/O address.
ZGIO-TKN-CHANNEL Subject token that specifies the channel number for the
event.
ZGIO-TKN-CHANNELTAG Channel tag parameter that is sent if the POLL response is
found. Correct values are %040001 or %040401.