NonStop Operating System Event Management Programming Manual

SCSI Module Driver Event Messages (ZSMD)
HP NonStop Operating System Event Management Programming Manual—520372-020
20-18
Messages
Unconditional Tokens
Cause. A SCSI module driver programming error has occurred. When present, the
SCSI Additional Status Token provides more information for development.
Effect. The command cannot be completed.
Recovery. See Recovery Action Requiring Vendor Support on page 20-12.
129: ZSMD-EVT-SVNET-CPU-TIMEOUT
The processor’s ServerNet hardware detected a ServerNet transfer timeout.
Unconditional Tokens
Cause. This timeout was caused by the controller hardware, congested ServerNet
traffic, or a ServerNet interconnect hardware problem.
Effect. The command cannot be completed.
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZSMD-EVT-
SVNET-SVC-INTF-ERR (128).
ZEMS-TKN-LDEV Subject token that contains the logical device number of the
affected disk drive.
Subject: ZEMS-TKN-LDEV
Potentially critical event: No
Action event: No
Message sender: DP2 Driver
TMDS collector: No
OSM/TSM collector: Yes
Unconditional Tokens
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-INT
ZEMS-TKN-LDEV token-type ZSPI-TYP-UINT
Event-Message Text
SCSI ServerNet Timeout
Token Description
ZEMS-TKN-EVENTNUMBER Event number for this message. Value is ZSMD-EVT-
SVNET-CPU-TIMEOUT (129).
ZEMS-TKN-LDEV Subject token that contains the logical device number of the
affected disk drive.