NonStop S-Series Hardware Installation and FastPath Guide (G06.25+)

Installing External System Devices
HP NonStop S-Series Hardware Installation and FastPath Guide—529443-001
7-11
Installing a 519x Cartridge Tape Subsystem
c. Find the uncapped SCSI port at the rear of the tape drive CRU. The uncapped
port is the SCSI port that does not have a SCSI terminator installed. See
Figure 7-8.
d. Using the SCSI cable connector with the latch-clip flanges, attach the SCSI
cable to the uncapped SCSI port and latch the clips.
e. Route the cable following the instructions in the 5190/5194 Modular Tape
Subsystem Manual.
2. Attach the SCSI cable to the NonStop S-series server. See Attaching a Tape Drive
to the NonStop S-Series Server on page 7-14.
3. Connect the AC power cord using instructions in the 5190/5194 Modular Tape
Subsystem Manual.
4. Push the AC power switch.