NonStop S-Series Hardware Installation and FastPath Guide (G06.25+)

Powering On and Starting the System
HP NonStop S-Series Hardware Installation and FastPath Guide—529443-001
8-3
Powering On External System Devices
7. Configure the server components of the OSM or TSM software package. To
configure and start OSM server processes, see the OSM Migration Guide.
8. With the OSM or TSM Low-Level Link, verify that the topology for the system has
been set correctly and that system components display the correct attributes.
9. Start the system, which includes loading the NonStop operating system into the
memory of each processor in the server and then reloading the processors.
Powering On External System Devices
Before you power on any system enclosures, power on the external system devices
and any other devices you want started when the system starts. External system
devices include system consoles, modems, and tape subsystems.
Powering On the Primary System Console and Modem
To power on the primary system console and modem, see Powering On a System
Console on page 5-8.
Powering On the Tape Subsystem
Choose one of these procedures to power on your tape subsystem:
Procedure Page
Powering On a 5175 Tape Subsystem
8-4
Powering On a 519x Tape Subsystem 8-5