NonStop S-Series Hardware Installation and FastPath Guide (G06.25+)

Configuring the System
HP NonStop S-Series Hardware Installation and FastPath Guide—529443-001
10-18
Construct a Nondedicated (Public) LAN
Configuration
Procedure
1. Connect the system console to the nondedicated (public) LAN as shown in
Figure 10-11.
a. Connect the Ethernet cable to the 10Base-T connector on the network
interface card (NIC) at the back of the system console.
b. Connect the other end of the Ethernet cable to the nondedicated (public) LAN.
c. Connect the nondedicated (public) LAN to the ServerNet adapter.
d. On the system console, configure the IP address for the console, and the
subnet mask and gateway for the nondedicated (public) LAN, as described in
Step 3 on page 10-4.
2. Install OSM or version 7.0 or later of the TSM client software. See the applicable
documentation:
°
NonStop System Console Installer Guide
°
TSM Online User Guide
°
OSM Migration Guide
When asked if the workstation is installed on a dedicated LAN, click No.
The OSM package should already be installed on the workstation, but it might be
configured for a dedicated LAN. If so, all OSM client applications appear in the
OSM Start Menu shortcuts, but you can use only the TSM Service Application, the
OSM Service Connection, and the OSM or TSM Event Viewer.
3. Use the OSM Service Connection or TSM Service Application to enter the IP
addresses for the ServerNet adapter. For instructions using TSM, see the TSM
Configuration Guide, For OSM, see the OSM Migration Guide.
4. Specify the TCP/IP process associated with the ServerNet adapter. For TSM, use
TEDIT or EDIT (see theTSM Configuration Guide). For OSM, see the OSM
Migration Guide.
5. Configure the OSM or TSM Event Viewer to use the TCP/IP process associated
with the ServerNet adapter. For instructions, see the OSM Migration Guide or TSM
Configuration Guide.
6. Test the nondedicated (public) LAN connection:
a. For OSM:
For the configuration changes made in the OSMCONF file (in steps 3-5) to
take effect, use the Reload Configuration Settings option from the Tools
menu in the OSM Service Connection. See the OSM User’s Guide for more
information.
For TSM: