NonStop S-Series Hardware Installation and FastPath Guide (G06.25+)

Glossary
HP NonStop S-Series Hardware Installation and FastPath Guide—529443-001
Glossary-92
S86000 server
S86000 server. See HP NonStop™ S86000 server.
S88000 server. See HP NonStop™ S88000 server.
Sxx000 server. See HP NonStop™ Sxx000 server.
S-series servers. See HP NonStop™ S-series servers.
SAC. See ServerNet addressable controller (SAC).
sag. A reduction in voltage, usually lasting from one cycle to a few seconds. Sags are
typically caused by fault clearing or by heavy load startups.
SAIL. See ServerNet Advanced Interface Logic (SAIL).
SAN. System area network. The preferred term is fabrics.
SANMAN. See external system area network manager process (SANMAN).
save file. A file created by the Inspect subsystem in response to a command from a
debugger. A save file contains enough information about a running process at a given
time to restart the process at the same point in its execution. A save file contains an
image of the process, data for the process, and the status of the process at the time
the save file was created.
A save file can be created through an Inspect SAVE command at any time. A save file
called a saveabend file can be created when a process’s SAVEABEND attribute is set
and the process terminates abnormally. Other debuggers can create a save file but
refer to the result as a process snapshot file. See also process snapshot file.
saveabend file. A file containing dump information needed by the system debugging tool.
(In UNIX systems, such files are usually called core files or core dump files.) A
saveabend file is a special case of a save file. See also save file and process snapshot
file.
saved-set group ID. An Open System Services (OSS) process attribute that stores a group
ID so that the group ID can later be used as the effective group ID of the process.
saved-set user ID. An Open System Services (OSS) process attribute that stores a user ID
so that the user ID can later be used as the effective user ID of the process.
save file. A file created by the Inspect subsystem in response to a command from a
debugger. A save file contains enough information about a running process at a given
time to restart the process at the same point in its execution. A save file contains an
image of the process, data for the process, and the status of the process at the time
the save file was created.
A save file can be created through an Inspect SAVE command at any time. A save file
called a saveabend file can be created when a process’s SAVEABEND attribute is set